1. Subject Content and Application Scope
This national standard specifies the maximum allowable emission limits of air pollutants for thermal power plants in periods. It's applicable to the emission management of existing thermal power plant as well as environmental impact assessment, design, final acceptance and post-construction emission management of the thermal power plant construction projects.
This national standard is applicable to the thermal power plants equipped with grate furnace (over 65t/h), coal-fired generation boiler excluding coal-throwing boiler, coal dust generation boiler, oil-fired generation boiler (over 65t/h) and compressor-turbine units. For the penetration boilers (65t/h) fired with biomass fuels like bagasse, sawdust and bark, the pollutant emission requirements shall be compliant to those of coal gangue-fired thermal power generation boilers.
This national standard is inapplicable to the thermal power plants fired with domestic wastes and hazardous wastes.
2. Normative References
The following standards contain provisions which, through reference in this text, constitute provisions of this national standard. For dated reference, subsequent amendments (excluding amending error in the text) to, or revisions of, any of these publications do not apply. However, the parties whose enter into agreement according to these specifications are encouraged to research whether the latest editions of these references are applied or not. For undated references, the latest edition of the normative document is applicable to this national standard.
GB/T 16157 Methods for article measurement and gaseous pollutant sampling of stationary pollution source emission
HJ/T 42 Measurement of nitrogen oxide in the stationary pollution source emission - ultraviolet spectrophotometry
HJ/T 43 Measurement of nitrogen oxide in the stationary pollution source emission - ethylene diamine dihydrochloride spectrophotometry
HJ/T 56 Measurement of sulfur dioxide in the stationary pollution source emission - iodimetry
HJ/T 57 Measurement of sulfur dioxide in the stationary pollution source emission - fixed-potential electrolysis method
HJ/T 75 Technical specification on continuous monitoring of thermal power plant fume emission
Monitoring and analysis methods of air and exhaust gas (China Environmental Science Press, 2003, fourth edition)