Standard No.:	QC/T 241-2024
English Name:	Air leakage detection methods of automobile wheels for tubeless tires
Chinese Name:	汽车无内胎车轮密封性检测方法
Chinese Classification:	T22    Bearing system
Professional Classification:	QC    Professional Standard - Automobile
ICS Classification:	43.040.50 43.040.50    Transmissions, suspensions 43.040.50
Source Content Issued by:	MIIT
Issued on:	2024-07-05
Implemented on:	2025-1-1
Status:	valid
Superseding:	QC/T 241-2011 Air leakage test methods of automobile wheels for tubeless tires
Target Language:	English
File Format:	PDF
Word Count:	6000 words
Translation Price(USD):	180.0
Delivery:	via email in 1 business day

QC/T 241-2024 Air leakage detection methods of automobile wheels for tubeless tires 1 Scope This document specifies six air leakage detection methods of automobile wheels, namely helium detection method, comparison detection method, hydrogen detection method, differential pressure detection method, water detection method and compressed air method. This document is applicable to automobile wheels equipped with tubeless tires. To be specific, helium detection method and water detection method are recommended for light alloy wheels; comparison detection method, hydrogen detection method, differential pressure detection method and compressed air method are recommended for steel wheels. 2 Normative references The following documents contain provisions which, through reference in this text, constitute provisions of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. GB/T 2933 Wheels and rims for pneumatic tyres - Vocabulary, designation and marking 3 Terms and definitions For the purposes of this document, the terms and definitions given in GB/T 2933 and the following apply. 3.1 leak rate amount of leakage caused by differential pressure per unit time Note: It is expressed in Pa·m3/s. 3.2 critical leakage rate leak rate threshold used to determine whether a part is acceptable 4 Samples The detection samples shall be unused new wheels or rims with uncoated surfaces. 5 Detection methods 5.1 Helium detection method 5.1.1 Detection equipment The detection equipment shall be equipped with a sealing device, which divides the wheel into two seal chambers, inner and outer, and shall be able to vacuum the two seal chambers. It shall be able to provide helium and detect the partial pressure of helium in the seal chamber of the wheel (see Figure 1).

Foreword i 1 Scope 2 Normative references 3 Terms and definitions 4 Samples 5 Detection methods 5.1 Helium detection method 5.2 Comparison detection method 5.3 Hydrogen detection method 5.4 Differential pressure detection method 5.5 Water detection 5.6 Compressed air method Annex A (Informative) Leak rate determination method