Contents
0 Introduction 1
1 Application Scope 1
2 Certification Standards 2
3 Certification Mode 3
4 Certification Unit Classification 4
5 Certification Entrustment 4
5.1 Proposal and Acceptance of Certification Entrustment 4
5.2 Application Information 4
5.3 Implementation Arrangement 5
6 Certification Implementation 5
6.1 Type Test 5
6.2 Certification Assessment and Determination 6
6.3 Certification Time Limit 6
7 Post-certification Supervision 7
7.1 Post-certification Follow-up Inspection 7
7.2 Sample Testing/Inspection on Production Site 7
7.3 Market Sample Testing/Inspection 8
7.4 Frequency and Timing of Post-certification Supervision 8
7.5 Record of Post-certification Supervision 8
7.6 Assessment of Post-certification Supervision Result 9
8 Certificate 9
8.1 Maintenance of Certificate 9
8.2 Change in Covered Products of Certificate 9
8.3 Expansion of Certificate Covered Product 10
8.4 Cancellation, Suspension and Revocation of Certificate 10
8.5 Use of Certificate 11
9 Certification Mark 11
9.1 Allowable Pattern of Mark 11
9.2 Marking Mode 11
10 Charge 11
11 Certification Responsibility 12
12 Certification Implementation Rules 12
Attachment: Unit Division for Low-Voltage Components and Parts 14
0 Introduction
On the basis of safety risks and certification risks, the Rule is prepared to specify the basic principles and requirements on implementing compulsory certification for low-voltage components and parts.
The Rule is used in association with CNCA general implementation rules like "Implementation Rule on Compulsory Certification - Selection and Determination of Classified Management and Certification Mode for Manufacturers", "Implementation Rule on Compulsory Certification - Utilization of Testing Resources and Other Certification Results of Manufacturers" and "Implementation Rule on Compulsory Certification - General Requirements of Factory Inspection".
The certification body shall, in accordance with the requirements of the general implementation rule and the Rule, prepare certification implementation rules, which shall be implemented in association with general implementation rule and the Rule.
The manufacturer shall ensure that its certified products continuously meet the requirements of certification and applicable standards.
1 Application Scope
The Rule is applicable to low-voltage components and parts whose working voltages are AC 1000V (to which AC 1140V [working voltage] electrical devices may refer) or DC 1500V and below. The following switch controllers and protectors are included.
