Nomenclature for fittings model
1 Scope
This standard specifies the nomenclature for fittings model.
This standard is applicable to fittings for overhead power lines, substations and power station distribution devices with rated voltage of 35kV and above.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
GB/T 1179 Round wire concentric lay overhead electrical stranded conductors
GB/T 2315 Specified failure load series and coupling dimensions for electric power fittings
GB/T 5075 Terminology for electric power fittings
3 General requirements for model nomenclature
3.1 The fittings model designations generally consist of Chinese phonetic alphabets (hereinafter referred to as letters) and Arabic numerals (hereinafter referred to as numbers), and Roman numerals or other numbers shall not be used.
3.2 The letters used in the designations shall be capitalized Chinese phonetic alphabets, and I and O shall not be used. Letters shall not be designated with corner marks.
3.3 The symbols used in the designation shall be multiplication sign (*), left slash (/), dash (-) and decimal point (.).
Foreword II
1 Scope
2 Normative references
3 General requirements for model nomenclature
4 Model designation composition
5 Nomenclature management for product model
6 Naming rules of product model
Annex A (Informative) Nomenclature examples for fittings model
Nomenclature for fittings model
1 Scope
This standard specifies the nomenclature for fittings model.
This standard is applicable to fittings for overhead power lines, substations and power station distribution devices with rated voltage of 35kV and above.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
GB/T 1179 Round wire concentric lay overhead electrical stranded conductors
GB/T 2315 Specified failure load series and coupling dimensions for electric power fittings
GB/T 5075 Terminology for electric power fittings
3 General requirements for model nomenclature
3.1 The fittings model designations generally consist of Chinese phonetic alphabets (hereinafter referred to as letters) and Arabic numerals (hereinafter referred to as numbers), and Roman numerals or other numbers shall not be used.
3.2 The letters used in the designations shall be capitalized Chinese phonetic alphabets, and I and O shall not be used. Letters shall not be designated with corner marks.
3.3 The symbols used in the designation shall be multiplication sign (*), left slash (/), dash (-) and decimal point (.).
Contents of DL/T 683-2010
Foreword II
1 Scope
2 Normative references
3 General requirements for model nomenclature
4 Model designation composition
5 Nomenclature management for product model
6 Naming rules of product model
Annex A (Informative) Nomenclature examples for fittings model
