1 Scope
This part of GB 10810 specifies the requirements for transmittance properties of spectacle lenses and relevant spectacle products made of any material. This part is applicable to relevant spectacle products, including: mounted spectacle lenses, completed sunglass, sunglass lenses, driving spectacles, polarizing spectacles, gradient-tinted spectacles and photochromic spectacles, etc.
This part is not applicable to:
——Spectacle lenses with special transmission or absorption properties used for medical purpose.
Note: The requirements for the optical and geometrical properties of spectacle products are already given in national standards such as GB 10810.1, GB 13511 and "Ophthalmic Optics-Spectacle Lenses-Fundamental Requirements for Uncut Finished Lenses" (equivalent to ISO 14889).
2 Normative References
Provisions in the following documents, through reference, become the provisions of this part of GB 10810. For dated references, subsequent amendments to (excluding any correction), or revisions of, any of these publications do not apply. However, parties to agreements based on this part are encouraged to investigate the possibility of applying the latest editions of these normative documents. For undated references, the latest edition of the referenced document applies.
GB/T 2828.1 "Sampling Procedures for Inspection by Attributea-Part1: Sampling Schemes Indexed by Acceptance Quality Limit (AQL) for Lot-by-lot Inspection"
GB 10810.1 "Spectacle Lenses: Part 1: Single-vision and Multifocal Lenses"
JJF 1106 "Calibration Specification of Transmittance Measuring Equipment for Ophthalmic Products"
ISO 13666 "Ophthalmic Optics-Spectacle Lenses-Vocabulary"
ISO 14889 "Ophthalmic Optics-Spectacle Lenses-Fundamental Requirements for Uncut Finished Lenses"
3 Terms and Definitions
For the purpose of this part of GB 10810, the following terms and definitions apply.
3.1
Visible radiation
Any optical radiation capable of directly causing a visual sensation.
There are no precise limits for the spectral range of visible radiation, since they depend upon both the amount of radiant power and the responsivity of the observer.
In the field of ophthalmic optics, the wavelength range of visible radiation is limited between (380~780)nm.
[ISO 13666, definition 4.2]
Foreword I
1 Scope
2 Normative References
3 Terms and Definitions
4 Classification
5 Requirements
6 Testing
7 Inspection Rules
8 Marking, Packaging, Transport and Storage
Annex A (Normative) Calculation Data for Visible Light Transmittance Properties
Annex B (Normative) Calculation Data for Solar Ultraviolet Transmittance Properties
Annex C (Informative) Principle Schematic Diagram of Transmittance Measuring Device for Spectacle Products
Annex D (Informative) Technical Differences and Causes between this Part and ISO 8980-3:
1 Scope
This part of GB 10810 specifies the requirements for transmittance properties of spectacle lenses and relevant spectacle products made of any material. This part is applicable to relevant spectacle products, including: mounted spectacle lenses, completed sunglass, sunglass lenses, driving spectacles, polarizing spectacles, gradient-tinted spectacles and photochromic spectacles, etc.
This part is not applicable to:
——Spectacle lenses with special transmission or absorption properties used for medical purpose.
Note: The requirements for the optical and geometrical properties of spectacle products are already given in national standards such as GB 10810.1, GB 13511 and "Ophthalmic Optics-Spectacle Lenses-Fundamental Requirements for Uncut Finished Lenses" (equivalent to ISO 14889).
2 Normative References
Provisions in the following documents, through reference, become the provisions of this part of GB 10810. For dated references, subsequent amendments to (excluding any correction), or revisions of, any of these publications do not apply. However, parties to agreements based on this part are encouraged to investigate the possibility of applying the latest editions of these normative documents. For undated references, the latest edition of the referenced document applies.
GB/T 2828.1 "Sampling Procedures for Inspection by Attributea-Part1: Sampling Schemes Indexed by Acceptance Quality Limit (AQL) for Lot-by-lot Inspection"
GB 10810.1 "Spectacle Lenses: Part 1: Single-vision and Multifocal Lenses"
JJF 1106 "Calibration Specification of Transmittance Measuring Equipment for Ophthalmic Products"
ISO 13666 "Ophthalmic Optics-Spectacle Lenses-Vocabulary"
ISO 14889 "Ophthalmic Optics-Spectacle Lenses-Fundamental Requirements for Uncut Finished Lenses"
3 Terms and Definitions
For the purpose of this part of GB 10810, the following terms and definitions apply.
3.1
Visible radiation
Any optical radiation capable of directly causing a visual sensation.
There are no precise limits for the spectral range of visible radiation, since they depend upon both the amount of radiant power and the responsivity of the observer.
In the field of ophthalmic optics, the wavelength range of visible radiation is limited between (380~780)nm.
[ISO 13666, definition 4.2]
Contents of GB 10810.3-2006
Foreword I
1 Scope
2 Normative References
3 Terms and Definitions
4 Classification
5 Requirements
6 Testing
7 Inspection Rules
8 Marking, Packaging, Transport and Storage
Annex A (Normative) Calculation Data for Visible Light Transmittance Properties
Annex B (Normative) Calculation Data for Solar Ultraviolet Transmittance Properties
Annex C (Informative) Principle Schematic Diagram of Transmittance Measuring Device for Spectacle Products
Annex D (Informative) Technical Differences and Causes between this Part and ISO 8980-3:
