Shipbuilding - Deck machinery - Warping end profiles
1 Scope
This document specifies the types, nominal sizes, dimensions, markings and selection rules of warping end profiles.
The warping end specified in this document is applicable to windlasses, mooring winches, capstans and other deck machinery with steel wire rope, and ropes of natural and man-made fibre.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 3828 Shipbuilding and marine structures - Deck machinery - Vocabulary and symbols
Note: GB/T 3893-2008, Shipbuilding and marine structures - Deck machinery - Vocabulary and symbols (ISO/FDIS 3828:2007, IDT)
ISO 8062-3 Geometrical product specifications (GPS) - Dimensional and geometrical tolerances for moulded parts - Part 3: General dimensional and geometrical tolerances and machining allowances for castings
3 Terms and definitions
For the purposes of this document, the terms and definitions given in ISO 3828 apply.
4 Types, nominal sizes and dimensions
4.1 Types
The document specifies two types of warping end profiles, as shown in Figure 1, namely:
——Type C - Common;
——Type E - Elongated.
4.2 Nominal sizes and dimensions
The nominal sizes and physical dimensions of the warping end are given in Figure 1 and Table 1.
Standard
GB/T 42690-2023 Shipbuilding—Deck machinery—Warping end profiles (English Version)
Shipbuilding - Deck machinery - Warping end profiles
1 Scope
This document specifies the types, nominal sizes, dimensions, markings and selection rules of warping end profiles.
The warping end specified in this document is applicable to windlasses, mooring winches, capstans and other deck machinery with steel wire rope, and ropes of natural and man-made fibre.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 3828 Shipbuilding and marine structures - Deck machinery - Vocabulary and symbols
Note: GB/T 3893-2008, Shipbuilding and marine structures - Deck machinery - Vocabulary and symbols (ISO/FDIS 3828:2007, IDT)
ISO 8062-3 Geometrical product specifications (GPS) - Dimensional and geometrical tolerances for moulded parts - Part 3: General dimensional and geometrical tolerances and machining allowances for castings
3 Terms and definitions
For the purposes of this document, the terms and definitions given in ISO 3828 apply.
4 Types, nominal sizes and dimensions
4.1 Types
The document specifies two types of warping end profiles, as shown in Figure 1, namely:
——Type C - Common;
——Type E - Elongated.
4.2 Nominal sizes and dimensions
The nominal sizes and physical dimensions of the warping end are given in Figure 1 and Table 1.
