Standard No.:	GB/T 5382-2008
English Name:	Performance and measurement method for braking force of motorcycles and mopeds
Chinese Name:	摩托车和轻便摩托车制动力要求及试验方法
Chinese Classification:	T80    Motorcycles in general
Professional Classification:	GB    National Standard
Source Content Issued by:	AQSIQ; SAC
Issued on:	2008-10-20
Implemented on:	2009-4-1
Status:	valid
Superseding:	GB 17355-1998 The target limit of brake performance for motorcycles and mopeds GB/T 5382.2-1996 Test method of brake performance for motorcycles and mopeds Braking force
Target Language:	English
File Format:	PDF
Word Count:	3000 words
Translation Price(USD):	124.0
Delivery:	via email in 1 business day

GB/T 5382-2008 Performance and measurement method for braking force of motorcycles and mopeds 1 Scope This standard specifies the terms, definitions, corresponding requirements, and test methods relating to the braking force of motorcycles and mopeds. This standard is applicable to motorcycles and mopeds (excluding off-road vehicles and racing vehicles). 2 Normative references The following standards contain provisions which, through reference in this text, constitute provisions of this standard. For dated references, subsequent amendments (excluding corrections) to, or revisions of, any of these publications do not apply to this standard. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the referenced document applies. GB/T 5359.5 Term for motorcycles and mopeds - Mass of vehicle with two wheels GB/T 5359.6 Term for motorcycles and mopeds - Mass of vehicle with three wheels GB/T 5378 General rules of running test for motorcycles and mopeds GB 20073-2006 Performance and measurement method for braking of motorcycles and mopeds 3 Terms and definitions For the purposes of this document, the terms and definitions given in GB/T 5359.5, GB/T 5359.6, and GB 20073-2006, as well as the following, apply. 3.1 braking force frictional resistance generated by the brake that forces the wheel rotation speed to decrease or causes it to lock up completely 3.2 axle load load borne by the front and rear axles of a vehicle under its complete vehicle kerb mass plus the weight of one driver 4 Requirements 4.1 The braking force of the front and rear axles of motorcycles and mopeds shall not be less than the limits listed in Table 1.

Foreword i 1 Scope 2 Normative references 3 Terms and definitions 4 Requirements 5 Test method Annex A (Informative) Braking force test record (format)