Road transportation test method for solid rocket motor
1 Scope
This standard specifies the conditions, equipment, requirements, procedures and result evaluation of road transportation test for solid rocket motor.
This standard is applicable to road transportation test for solid rocket motor (hereinafter referred to as motor).
2 Normative references
The following normative documents contain provisions which, through reference in this standard, constitute provisions of this standard. For dated references, subsequent amendments (excluding corrections) to, or revisions, of any of these publications do not apply to this standard. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition applies.
GB 2702-1990 Safety boxes for explosives
GJB 2001-1994 The safety requirements of package, transport and storage for initiating explosive device
GJB 3389-1998 Safety prescript for hoisting of solid rocket motor
QJ/T 815.1-1994 Road transportation simulation test method for product
QJ 1354A-2005 General technical requirements for painting, external marking and packing of solid rocket motors
QJ 3160-2002 Railway transportation test method for solid rocket motors
JTJ 01 Technical standard of highway engineering
3 Test purpose
For the purpose of assessing the environmental adaptability and structural integrity of the motor under road transportation conditions.
4 Test conditions
4.1 Road class
Road class is generally in accordance with Class II and Class IV roads specified in JTJ 01.
4.2 Transportation speed
The transportation speed is in accordance with the following requirements:
a) Class II road: 30km/h~60km/h.
b) Class IV road: 15km/h~40km/h.
4.3 Transportation mileage
Foreword II
1 Scope
2 Normative references
3 Test purpose
4 Test conditions
5 Test equipment
6 Test requirements
7 Test procedures
8 Evaluation of test results
9 Test report
Road transportation test method for solid rocket motor
1 Scope
This standard specifies the conditions, equipment, requirements, procedures and result evaluation of road transportation test for solid rocket motor.
This standard is applicable to road transportation test for solid rocket motor (hereinafter referred to as motor).
2 Normative references
The following normative documents contain provisions which, through reference in this standard, constitute provisions of this standard. For dated references, subsequent amendments (excluding corrections) to, or revisions, of any of these publications do not apply to this standard. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition applies.
GB 2702-1990 Safety boxes for explosives
GJB 2001-1994 The safety requirements of package, transport and storage for initiating explosive device
GJB 3389-1998 Safety prescript for hoisting of solid rocket motor
QJ/T 815.1-1994 Road transportation simulation test method for product
QJ 1354A-2005 General technical requirements for painting, external marking and packing of solid rocket motors
QJ 3160-2002 Railway transportation test method for solid rocket motors
JTJ 01 Technical standard of highway engineering
3 Test purpose
For the purpose of assessing the environmental adaptability and structural integrity of the motor under road transportation conditions.
4 Test conditions
4.1 Road class
Road class is generally in accordance with Class II and Class IV roads specified in JTJ 01.
4.2 Transportation speed
The transportation speed is in accordance with the following requirements:
a) Class II road: 30km/h~60km/h.
b) Class IV road: 15km/h~40km/h.
4.3 Transportation mileage
Contents of QJ 2317A-2005
Foreword II
1 Scope
2 Normative references
3 Test purpose
4 Test conditions
5 Test equipment
6 Test requirements
7 Test procedures
8 Evaluation of test results
9 Test report
